Book Now
Error Code Reference

KitchenAid Dryer Error Code F24

This error code indicates a door latch or door switch failure, meaning the dryer's control system cannot detect that the door is properly closed and latched. This is a safety feature that prevents the dryer from operating when the door isn't secure.

Technical Advisory
Home › Error Codes › KitchenAid Dryer Error Code F24

Signs

What you may observe

• Dryer will not start or begin a cycle • Door appears closed but dryer won't run • Error code F24 displays on the control panel • Dryer may stop mid-cycle and display the error • Door latch may feel loose, worn, or not click into place properly • Dryer drum does not rotate when attempting to start

Possible Causes

Root causes behind this error

• Door latch mechanism is broken, worn, or misaligned • Door strike (catch) is bent or damaged • Door switch is faulty and not sending proper signal to control board • Worn door seal causing improper door closure • Control board not receiving door closure signal due to electrical connection issue • Repeated slamming has loosened the latch assembly • Lint or debris interfering with door latch engagement • Defective door switch preventing the dryer from recognizing when door is closed

Safety Checks You Can Do

Steps you can try at home safely

• Verify the circuit breaker for the dryer is in the ON position and has not tripped; reset if necessary • Ensure the dryer door is fully closed and listen for a distinct clicking sound when latching • Open the door and inspect the latch and strike for visible damage, cracks, or misalignment • Remove any lint, debris, or obstructions around the door frame and latch area • Clean the lint filter thoroughly and ensure it sits properly in its slot • Check that the dryer vent hose is not kinked or blocked, allowing proper airflow • Review your dryer's control panel settings to ensure you've selected appropriate cycle and temperature settings • Allow the dryer to cool for 30 minutes, then attempt to start a new cycle • Perform a full reset by switching the circuit breaker OFF for 60 seconds, then switching it back ON and attempting to start the dryer again • If the error persists after these steps, the door latch assembly or door switch likely requires professional replacement
Your Area

Ready to Book a Service?

Our team is available in your area and ready to help.

Schedule Now Call Us