Book Now
Error Code Reference

KitchenAid Washer Error Code F07

Error F07 indicates a communication or control board malfunction in your KitchenAid washer. This error typically means the washer's main control board is not properly communicating with other components, preventing normal operation.

Technical Advisory
Home › Error Codes › KitchenAid Washer Error Code F07

Signs

What you may observe

• Washer will not start or complete a cycle • Display shows F07 error code • Drum does not rotate during wash cycle • Water may not fill or drain properly • Control buttons are unresponsive or intermittent • Washer powers on but fails mid-cycle • Unusual beeping or no response from console

Possible Causes

Root causes behind this error

• Loose or corroded electrical connections between control board and motor • Faulty main control board or user interface board • Damaged wire harnesses or connectors from power surge or moisture • 120V power supply fluctuations affecting control board function • Failed door/lid latch switch preventing cycle recognition • Water level sensor malfunction preventing proper cycle progression • Overloaded wash cycle causing excessive motor draw that triggers safety shutdown • Defective motor or motor connection with inadequate voltage supply

Safety Checks You Can Do

Steps you can try at home safely

• Check that your home's circuit breaker for the washer is in the ON position; if tripped, switch it OFF then ON again • Verify the washer door or lid closes completely and latches fully with an audible click • Confirm both hot and cold water supply valves behind the washer are fully open (turn counterclockwise) • Inspect the drain hose for kinks, pinches, or blockages; ensure it is not crimped • Reduce the size of your laundry load to prevent motor strain and control board overload • Review your cycle settings to ensure you selected an appropriate wash cycle for your load type • Unplug the washer or turn off the dedicated circuit breaker for 60 seconds, then restore power to reset the control board • Allow the washer to sit unpowered for at least 2 minutes before attempting to restart • Check if the error clears after a complete power cycle; if it returns, the control board likely requires professional service
Your Area

Ready to Book a Service?

Our team is available in your area and ready to help.

Schedule Now Call Us