Book Now
Error Code Reference

KitchenAid Oven Error Code F2/E0

This error code indicates a problem with the oven's temperature sensor (RTD probe) or its electrical connection. The oven has detected an issue preventing accurate temperature monitoring, which is critical for safe and proper cooking.

Technical Advisory
Home › Error Codes › KitchenAid Oven Error Code F2/E0

Signs

What you may observe

• Oven will not heat or preheat properly • Display shows F2/E0 error code • Oven may shut off during cooking cycles • Unable to set or maintain desired temperature • Preheat cycle fails to complete • Oven beeps repeatedly and locks out cooking functions • Temperature may fluctuate erratically on display

Possible Causes

Root causes behind this error

• Temperature sensor (RTD probe) failure or degradation • Loose or disconnected sensor wiring harness • Damaged or frayed sensor wire from repeated opening/closing • Poor electrical connection at sensor terminal block • Corroded or oxidized sensor contacts • Sensor wire pinched or crushed during oven assembly • Control board failure unable to read sensor signal • 240V/120V power supply fluctuations affecting sensor circuit

Safety Checks You Can Do

Steps you can try at home safely

• Verify the circuit breaker serving your oven is in the ON position; if tripped, reset it and attempt to use the oven again • Ensure the oven door is fully closed and latches completely with no obstructions • Check that your oven is receiving proper electrical power by confirming other kitchen appliances on the same circuit are functioning • Review your oven's control panel settings to confirm no override modes or diagnostic tests are active • Allow the oven to cool completely for at least 30 minutes before attempting any troubleshooting • Perform a complete reset: Turn off the circuit breaker serving the oven for exactly 60 seconds, then turn it back ON and wait 5 minutes before attempting to use the oven • If error persists after reset, unplug the oven from the wall outlet for 60 seconds if it's a 120V model, or switch off the dedicated breaker for 60 seconds if it's a 240V model • Do NOT attempt to access, test, or replace the temperature sensor yourself as this requires professional calibration and may void your warranty
Your Area

Ready to Book a Service?

Our team is available in your area and ready to help.

Schedule Now Call Us