Book Now
Error Code Reference

KitchenAid Refrigerator Error Code Er FS

This error code indicates a freezer temperature sensor malfunction or failure on your KitchenAid refrigerator. The appliance is unable to accurately read the freezer compartment temperature, which affects cooling performance and food preservation.

Technical Advisory
Home › Error Codes › KitchenAid Refrigerator Error Code Er FS

Signs

What you may observe

• Freezer compartment not maintaining proper temperature • Fresh food section becoming too cold or not cold enough • Error code Er FS displayed on the control panel or digital display • Refrigerator cycling on and off more frequently than normal • Ice buildup or lack of ice production in ice maker • Frost accumulation in freezer section • Alarm or beeping sounds from the appliance • Compressor running continuously or not running at all

Possible Causes

Root causes behind this error

• Faulty or defective freezer temperature sensor (thermistor) • Loose or disconnected wiring harness to the temperature sensor • Ice buildup blocking the sensor probe in the freezer wall • Damaged control board unable to read sensor signals • Corroded sensor connections due to moisture or humidity • Manufacturing defect in the sensor component • Control board failure preventing proper temperature monitoring • Refrigerant flow issues causing inaccurate temperature readings

Safety Checks You Can Do

Steps you can try at home safely

• Verify the circuit breaker for the refrigerator is in the ON position and hasn't tripped • Confirm both the refrigerator and freezer doors are fully closed and seal properly • Check that temperature control settings are set to normal levels (not too cold) • Inspect visible air vents inside the freezer for blockages from food or ice buildup and clear if needed • Ensure there is proper clearance around the back and sides of the refrigerator (minimum 2-3 inches) for adequate airflow • Clean the condenser coils on the back or bottom of the refrigerator using a soft brush or vacuum (refer to your user manual for location) • Perform a hard reset by unplugging the refrigerator for 60 seconds, then plugging it back in to clear temporary error codes • Alternatively, turn off the circuit breaker for 60 seconds and turn it back on to reset the control board • Allow 24 hours after reset before determining if error persists • If error code returns, the appliance likely requires professional service or sensor replacement
Your Area

Ready to Book a Service?

Our team is available in your area and ready to help.

Schedule Now Call Us