Book Now
Error Code Reference

KitchenAid Dishwasher Error Code F2-E1

This error code indicates a water inlet valve or water supply issue on your KitchenAid dishwasher. The appliance is detecting that water is not filling properly or at the expected rate during the wash cycle.

Technical Advisory
Home › Error Codes › KitchenAid Dishwasher Error Code F2-E1

Signs

What you may observe

• Dishwasher fails to fill with water during the wash cycle • Cycle stops mid-operation • Error code F2-E1 displays on the control panel • Dishwasher runs but produces no cleaning action • Unusual sounds from the water inlet area • Reduced water pressure inside the dishwasher tub

Possible Causes

Root causes behind this error

• Water inlet valve is stuck, defective, or has failed • Water supply line is kinked, pinched, or restricted • Clogged water inlet filter screens (sediment from municipal water supply) • Main water shutoff valve to dishwasher is partially or fully closed • Water pressure to the home is below the minimum requirement (20 PSI) • Faulty water level sensor or control board • Frozen water inlet hose (in cold climates) • Incorrect installation of water supply connections • Malfunctioning fill valve solenoid

Safety Checks You Can Do

Steps you can try at home safely

• Turn off the dishwasher and check that the main circuit breaker for the appliance is in the ON position; if tripped, switch it OFF for 60 seconds, then back ON to reset the system • Ensure the dishwasher door is fully closed and the door latch is engaged properly • Locate the water supply valve under the sink and verify it is fully open (turned counterclockwise) • Inspect both the hot and cold water inlet hoses connected to the dishwasher for kinks, twists, or pinches that could restrict water flow • Remove and inspect the water inlet filter screens located at the water valve inlet connections; rinse any sediment or debris under running water • Check that you are using the correct dishwasher detergent type and proper dosage as specified in your user manual • Review the control panel settings to confirm the correct wash cycle is selected and not in delay-start or pause mode • Perform a complete reset by turning off the circuit breaker to the dishwasher for a full 60 seconds, then restore power and attempt to run a short test cycle • Verify that the home's main water supply is flowing normally to other fixtures (sink, shower) to rule out a whole-house water pressure issue
Your Area

Ready to Book a Service?

Our team is available in your area and ready to help.

Schedule Now Call Us